Robot_Principal_2024-2025/main controller code

Motion controler code for the RPI Pico (RP2040)

This project is the main controller firmware for the RPI Pico (RP2040), designed for the Eurobot 2025 Cup.

I2C description

The robot’s I2C communication works as follows:

• Send the device address + R/W bit (to select read or write mode).
• Send the target register address (to read from or write to).
• Read or write the register data. Multiple registers can be read/written sequentially, with the address auto-incrementing after each operation.

This code is designed to be the master in the i2c communication;

Adress	R/W	Description	Encoding
0x00	W	Speed motor 1	-128 - 127
0x01	W	Speed motor 2	-128 - 127
0x02	W	Speed motor 3	-128 - 127
0x03	W	Speed motor 4	-128 - 127
0x04	W	Servo 1 position selection	0 - 1
0x05	W	Servo 2 position selection	0 - 1
0x06	W	Servo 3 position selection	0 - 1
0x07	W	Servo 4 position selection	0 - 1

Motors communication description

Motors are «connected» to their respective I2C buffer address.

To control a motor you need to write data to its adress of the form :

int8_t speed;

Value goes from -128 to 127.

Servo motors communication description

Servo motors are «connected» to their respective I2C buffer address.

To control a servo motor you need to write data to its adress of the form :

uint8_t close;

Value is 0 or 1 for the open or the close pos.